WC166A
6" Drum Chipper
| Feed Type | Self Feed Drum |
| Feed Type | Self Feed Drum |
| Chipping Capacity | 6 in |
| Paint | Powder Coat |
| Weight (approx) | 3590 lb |
| Length (Transport) | 13 ft 3 in |
| Length (Operational) | 17 ft 2 in |
| Width | 7 ft 3 in |
| Height | 7 ft 10 in |
| Infeed Chute Size | 26 in H x 42 in W |
| Folding Table Size | 44 in W x 50 in L |
| Total Length from Ground to Nip Point | 105 in |
| Axle | 6000 lb Torflex With EZ Lube Bearings |
| Brakes | Electric (Self-Adjusting) |
| Tires | ST 225/75R-15E |
| Rims | 6 Lug - 1/2 in Stud 15 in x 6 in |
No Hydraulic Systems.
| Frame Material | 2 in x 6 in Channel | Front Jack | 5000 lb Lift |
| Tongue Length | 28 in - 34 in | Hitch Height Adjustable | 2 Position 20 in to 24.5 in |
| Fuel Tank Composite | 26 Gal | Lighting | L.E.D. / DOT Compliant |
| Battery 12 Volt DC | CCA Diesel = 1000 Amps | Standard Battery Box | Composite |
| Standard Fenders | Alum Tread Plate | Cutter Disc/Drum Size | 12 in Dia x 16 in L |
| Cutter Disc/Drum RPM / Weight | 2700 RPM / 311 lb | Disc/Drum Bearings | 2 15/16 in Dia |
| Belt | Kevlar, Banded 2-Groove (48 HP Engine) | Knives | (4) - 12 in x 3 in x .375 in Serrated |
| Anvil | 4-Sided 12 in x 3 in x 0.75 in | Drum/Disc Housing Material | 0.75 in Side Plates / 0.25 in Top Plate / 0.5 Feed Plate |
| Discharge Chute | 2 Piece With Side-Discharge Tube |
| ANSI Z133.1 | Designed to Meet or Exceed |
| Chip Deflector Curtain | Standard |
| Maintenance Cutter Lock | Standard |
| Engine Shutdown System (low oil/high temperature) | Standard |
| Controls Location | Curb Side |
| Safety and Instructional Decals | Standard |
| Safety Chains on Hitch | 3/8 in |
| 48 HP Kubota (Diesel) | Standard |
| 67 HP Kubota (Diesel) | Optional |
| 70 HP Ford 2.3L (Gas) | Optional |
| 85 HP Kubota (Diesel) | Optional |
| Steel Fenders | Optional | Caster Wheel Jackstand | Optional |
| Cone Holder | Optional | Debris Pusher | Optional |
| Flag Holders | Optional | Fuel Tank Gauge | Standard |
| Height Adjustable Discharge Chute | Standard | Rear Engine Cut Off | Optional |
| Rear Jack Stand | Standard | Single-Axle Frame Configuration | Standard |
| Spare Tire / Rim | Optional | Strobe Light | Optional |
| Tool Box | Optional | Wheel Chocks and Holders | Optional |
Altec Environmental Products 210 Inverness Center Drive, Birmingham, AL 35242
Phone: 800-958-2555 | Fax: 205-449-4774 | sales@altec.com